Escient FireBall H-40 Remote control Manual do Utilizador descarregar pdf (Página 96)

TheaterTouch Designer

RS-232 TAB (ALL DEVICES)

The RS-232 Tab allows an RS-232 command to be assigned to the selected button. The RS-232 function is available

only if you include a control processor in the system.

CREATE NEW RS-232 CODE

1. Select Create New RS-232 Code to add an RS-232 command to

the selected button.

SERIAL COMMUNICATION SETTINGS

2. Select the desired communications Baud Rate, Data Bits, Parity

and Stop Bits from this control. The rates must match the

equipment you are controlling. Consult the documentation for

the equipment being controlled to obtain the proper values (if

you do not find a stop bit value, leave the default of 1.)

OUTPUT SETTINGS

3. Delay between characters – This adjusts the amount of

time the device waits after each character of a string is sent out.

Increasing the wait time provides additional time for slow receiv

ing equipment. This value will not require adjustment with most

equipment.

4. Sustain – Select Sustain to have the RS-232 string sent repeat-

edly for as long as the button is held down.

5. Delay between repeats – Set the amount of time between

repetitions of the RS-232 code. This option is only available

when the Sustain option is selected. RS-232 commands are

issued quickly and should be set to .1 or .2 seconds to obtain

acceptable ramping rates for volume and channel up or down

commands.

6. Output Port – Select the output port connected to the compo-

nent receiving the RS-232 command.

RS-232 STRING

7. Hex – Select this button to toggle between editing the RS-232 command in ASCII mode and Hex mode.

8. Choose OK to confirm the new settings.

Note: A red letter C on the button indicates the command.

Note: If you should need more than 200 characters in a command, you can make a macro with two or more com

mand strings without any time delay between them. See Adding an RS-232 Command to a Button - Chapter 7 for

more details about entering command strings.

1 2 ... 91 92 93 94 95 96 97 98 99 100 101 ... 144 145

Sem comentários

Escient FireBall H-40 Remote control Manual do Utilizador Página 96